The carpeted rooms and computer chairs wheeled around do not work well without some sort of mat or hard surface on the carpet under the desk chair mat. The plastic mats are only partially effective, since the wheels sink into the chair leaving small plastic notches that prevent the wheels from moving.
12 Photos Gallery of: How to Make a Hard Surface for Desk Chair Mat
- The typical plastic mat measures 40 by 42- inch deep by width “x” inches behind the desk chair mat to roll and 12 to 14 inches long for fit feet under the table and rested.
- Assemble the first two parts of the floor. Place a piece of the floor face up on a large table. On the tongue of a second piece, put a drop of glue.
- Repeat the first step with other parts keeping the ends carefully aligned and assembled until you have 6 pieces.
- Using a saw, a piece split lengthwise down the middle.
- With glue, the two parts mounted on the ends of the assembly parts 6 and joining interlacing.
- Place wooden set upside down on a flat surface. Use a line to lower edges of the sides of the timber assembly guide.
- Measure the width of the available space under the desk chair mat for the feet and knees. This will be the width of the reed mat.