Planning Barn Doors

Dec 2nd

Barn doors are probably not much considered as one of home improvement ideas. Planning the doors for barn is actually important to increase your home value. Good planning is necessary to hang a barn door divided due to the large size of its panels. First, orders or build two barn doors sectioned. Then, frames the opening for the door in the wall of the barn. Now, it’s time to install the lane to the barn door. Instructions: Cut a mounting board with the length measurement. Mark the center framed barn door at the top of the inner wall. Make a pencil mark where the lane overhanging the edge of the table. Cut the rail using the hacksaw. Drill holes for fastening bolts on steel rail according to the manufacturer’s instructions.

Contemporary Barn Doors
Contemporary Barn Doors

Sets the lane barn doors on the widest part of the table 1×4 (2,54×10,16 inches). Mark the location of the holes in the rail on the table. Drill the table at each location. Clava the mounting board to the inside of the barn at the top of the opening . Make sure the table is level and perpendicular to the floor.

12 Photos Gallery of: Planning Barn Doors

Image of: Contemporary Barn Doors
Image of: Vintage Barn Doors
Image of: Rustic Barn Doors
Image of: Oak Barn Doors
Image of: Modern Barn Doors
Image of: DIY Barn Doors
Image of: Barn Doors
Image of: Barn Doors Picture
Image of: Barn Doors Indoor
Image of: Barn Doors Image
Image of: Barn Doors Design
Image of: Antique Barn Doors
 

Screw fixing bolt through each hole and countersink drill bit used in variable speed drill to screw the bolts in the wall mounts. Hold the rail steel barn doors against the mounting board. A clamping bolt pushing through each hole in the corresponding channel of the mounting board.