Traditional barn door hardware is the famous door slats. This consists of vertical boards on the outside and horizontal boards (strips) on the reverse or inside. This pattern gives you strength perpendicular to the door and helps minimize distortion. Two doors swinging in opposite directions and meet in the middle when closed is a common feature of the barns.
The overlapping pine is a practical building material for barn doors. The term “overlapping” refers to cutting the top edge of each plate. When the plates are placed edge to edge, these boards overlap. Pine is usually lapped 8 inches (20 cm), 10 inches (25 cm) wide and 12 inches (30.5 cm) and is commonly available in lumber yards and supply stores for home. The choice of fasteners is important. Since the barn door hardware have set, it is essential that they resist corrosion.
12 Photos Gallery of: Building Exterior of Barn Door Hardware
Measuring horizontally and dividing door 2, the approximate width of each barn door is obtained. Make the size slightly larger doors, and then cutting it to the exact size as the last step, allowing a custom fit. This is an important detail because a barn door hardware is opened often be out of frame with different vertical measurements on one side and the other and different horizontal at the bottom and top.